To do an invisible joint, rather than using metal strips, a high quality worktop jig which can be used to guidebook the router together the worktop in a selected way plus a top quality router with a 30mm collar and extended shank twelve.7mm cutter are going to be required. These expert tools might be employed from the Instrument hire store or If you’re a eager or professional carpenter they can be purchased at any fantastic Device shop or online.
Most worktop jigs will not include any method of Recommendations and those that do are little in excess of an evidence about which gap does what, but even more instructions on their use are available.
To find the point wherever the joint starts, set the 1st bit of worktop in place, after which lay the second piece on top rated in the correct posture.
The two worktops will cross above each other at the postform edge and Here is the start off of the Slice. Spot a piece of calacatta quartz masking tape on the first worktop so that the position with the crossover may be transferred on to the masking tape.
If there is ample worktop it is best to cut them a bit extensive, in the event that they get broken and should be re-trimmed after the joints are carried out.
Wherever probable it’s best to begin with the remaining to accomplish the butt side of your joint so which the piece to get scribed is on prime, permitting the pencil marks to point out easily over the underside.
Align the worktop jig up on the pencil line, given that the jig Directions display or if no instructions are available then a whole guide and DVD could possibly be found on the internet.
When the 1st bit of worktop has gained the initial cut the next piece is placed on major so that it may be marked with a sharp 2h pencil. Mark two points alongside the cut to point out the place the Reduce has got to take place.
The worktop is put upside down to the workbenches to have the ability to see The 2 strains Beforehand drawn.
A short explanation about the router. A 12.7mm router cutter by using a lengthy shank is equipped into the router. On the base from the router is put a collar that’s 30mm in diameter – That is employed to be a guidebook to suit into the 30mm slot inside the worktop jig.